Non-Amplified TV Antennas

Cable television headend is a master facility for receiving television signals for processing and distribution over a cable television system. more...

Home
A/V Accessories & Cables
Antennas
AM/FM Antennas
Amplified TV Antennas
HDTV Antennas
Non-Amplified TV Antennas
Other
Outdoor TV Antennas
Satellite Radio Antennas
Audio Cables & Connectors
Blank Media
Headphones, Headsets
Maintenance & Care
Mounts & Brackets
Other A/V Accessories
Remote Controls
Surge Protection, Filtration
Video Cables & Connectors
Apple iPod, MP3 Players
DVD & Home Theater
Gadgets & Other Electronics
Home Audio
MP3 Accessories
Portable Audio/Video
Radios: CB, Ham & Shortwave
Satellite Radio
Satellite, Cable TV
Telephones & Pagers
Televisions

The headend facility is normally unstaffed and surrounded by some type of security fencing and is typically a building or large shed housing electronic equipment used to receive and re-transmit video over the local cable infrastructure. One can also find headends in power line communication (PLC) substations.

Reception

The cable TV headend will normally have several large FSS-type television receive-only satellite television dishes for reception of cable/satellite TV networks such as ESPN, CNN, or HBO; a dedicated, non-movable dish is required for each satellite that the cable TV utility wishes to receive cable channels from for distribution over its system. For reception of signals from several adjacent satellites, a larger non-parabolic multi-satellite dish (such as the Torus or Simulsat) that can see up to 3 or more satellites is often used. Many digital cable systems use services like HITS ("Headend in the Sky", a unit of Comcast distributed by the Comcast Media Center), which carry hundreds of channels on just a few satellites; this is commonly used by small systems to expand service without adding expensive new dishes or other equipment.

Cable TV systems usually also carry local over-the-air television networks for distribution. Since each terrestrial channel represents a defined frequency, a dedicated commercial-grade receiving antenna is needed for each channel that the cable company wishes to receive and distribute. These antennas are often built into a single tower structure called a master antenna television structure. Often, commercial TV pre-amplifiers are used to strengthen weakened terrestrial TV signals as much as possible before distribution.

Some cable TV systems receive the local television stations' programming by instead having a dedicated coaxial or fiber-optic line installed between the local station and the headend. A device called a modulator is installed at the local station's facilities to feed their programming over this line to the cable TV headend, which in turn receives it with another device called a de-modulator. It is then distributed through the cable TV headend to the subscriber. This is usually a more reliable method than receiving the local stations' broadcasts over the air with an antenna, however, off-air reception is used as a backup by the headend if the dedicated line, modulator or demodulator were to fail.

Other sources of programming include those delivered via fiber optics, telephone wires, the Internet, microwave towers and local community access channels that are sent to the cable headend on an outbound frequency over the cable system itself (known in the industry as "T"-channels), or via a dedicated line set up by the cable company, as mentioned earlier for reception of local television stations' programming by the headend.

Read more at Wikipedia.org